433MHz 12V Wireless Garage Door/Motor/Car/Light Remote Controller Switch 10A 2CH Relay Receiver Module with Keyfob Transmitter

DC 12V 2 Channel Relay Receiver

1.The receiver board needs DC 12V voltage to power on.The relay can connect with 1-250V voltage;
2.Two channel receiver, can make motor forward and reverse.So you can use it to control your motor/garage/gaet/door/light;
3.10A relay,suitable for most devices;
4.Three modes: Momentary,Toggle and Latched ,to meet different environment

2 buttons remote transmitter

1.There are two different remotes, all can work with this receiver
2.Stable RF signal,can pass through walls.Support 50 m control in open space
3.Remote is small size and has keychain,you can put it into your pocket

Receiver parameter

Working power: DC 12V
Size: 1.8*1.5*0.7 in(46*38*17 mm)
Max current: 10A
Code: 1527 learning
Can be controlled: 20 pcs remotes
Port: +V,-V,NO,NC,COM

Remote parameter

Battery: 1*27A12V OR 2* CR2016 (Include)
With: keychain
Material: pvc
Code: 1527 learning
Button: 2
Range: support 50 m in open space

Application

It can control lights on off. It can control AC and DC motor.

Stable rf signal and multi control

One receiver can be controlled by 20pcs remotes;
One remote can control 5pcs receivers at most

Product detail

NO=Normal Open,NC=Normal Close,COM=Common port
1.Protective Housing: Protect components from damage during shipping and using
2.Receiving Module: Receive signal from transmitter
3.Antenna: Extend receiving distance
4.Learning Button: Press learing button to set up mode
5.Indicator: Light when connected with power
6.Blue Protection Terminal: High voltage protection
7.+12 -12V: Power port

Remote detail

Wiring Diagram
This receiver can work with lamps,bulbs,lights,etc.The receiver itself needs DC 12 V power.And there are two different wirings depends on whether there is an external power too.Here are two pictures:
This receiver can also work with AC and DC motors, to make them forward and reverse. Here are two pictures :
Three operating mode
You can match the Transmitter with the Relay Receiver Module in 3 modes.
Momentary Mode:
1. Press and hold one button, 1st relay will turn on;
2. Release the button, 1st relay will turn off.

Toggle Mode:
1. Press button “A”,1st relay will turn on;
2. Press button “A” again, this relay will turn off.

Latched mode:
1. Press button “A”, 1st relay will turn on;
2. Press button “B”, this relay will turn off.

Delete the existing data about operating modes
Press the learning button (on the Receiver) 8 times. The existing data will be deleted succeed.
Note:
1. When you receive our products, it may set in one remote mode randomly, that because each product was tested before it can be arranged to shipment. So, please delete the existing data to first use.
2. After deleted the data, all the remote controls cannot work any more.
How to set up in these three modes
Set up(Momentary)

1. Press the learning button(on the Receiver)once. the indicatior lights up;
2. Press A button 1 time;
3