Kawa SS80 wall mounted watertight motion sensor switch

User MANUAL

Motion Infrared Touch Device: Kw – SS80

Introduce

This is a touch device with the movement of objects with a body temperature greater than ambient temperature combined with a touch brightness adjustment function to save electricity, because The light can be adjusted only when it’s dark and someone moves.

Actual APPLICATION

Technical SPECIFICATION

Power voltage: 180~230V.

Frequency: 50Hz.

Load capacity: 1200W (incandescent). 300w (LED).
Scanning angle from left to right: 180o

Maximum sensor distance: 3~4m.

Installation height from 1.5 to 2.5 m.

Adjust delay time from 10 seconds to 8 minutes.

Adjust brightness from 10 lux to 2000 lux.

Power Consumption: 0.45W.

Adjustable knobs:

Time knob: Used to adjust delay TIME.
Lux Knob: Used to adjust Lux degree (light on/off brightness).

User MANUAL:

When it’s dark, if someone moves in the touch scanning area, immediately the contact inside will close the switch to turn on the light (can install the siren when someone breaks the horn. Indicator using voltage 220v).

We install the touch connected to the existing bulb and adjust it so that the scanning angle is towards someone moving, then adjust the 2 buttons: the time button turns off the light, the adjustment button. Touch brightness.

Example:

* Time button: turn the TIME button (TIME) in the middle is about 3~4 minutes will turn off after leaving the touch area. (adjustable TIME from 10 seconds to 8 minutes).

* Light button: turn the LUX button towards the moon, only touch when there is not enough light (when it is dark), this function saves electricity because during the day there is light The sun should not touch.

Installation:

Turn off the power before disassembly.

Use a screw to remove the screw at the bottom of the sensor, then remove the plastic cover behind.
Wiring according to the drawing above, then drill 2 holes in the wall using screws to fix the plastic cover and then assemble the touch on the wall so that the touch lens is facing the area to be touched or In the direction often someone goes back and forth. Adjust the lux and appropriate delay time then power the touch work.

Connect power cord L: power cord 220v in, N: connect 220v in and 1 output cord., A: out load.

Note:

+ +) If you want to test daylight, adjust the LUX knob towards the sun arrow.

+) If used for the office, it is recommended to adjust the lux level by about 50% of the adjustment range, adjust the delay time from 3 to 7 minutes (About 50 to 100% of the time adjustment range).

+ +) Do not install the device near an obstacle that covers the touch eye.

+) Avoid placing the device in places with high ambient temperatures such as air conditioners, heaters….

+) For safety, you do not open the device yourself when you do not understand the device.

+) +) To avoid unwanted damage of the product, you should install an additional fuse or other safety equipment.