Lufi XF Revolution OBD2 Multi-Data Heads Up Display Highly Customizable, Accurate and Fast Response [Will NOT Work with Cars Before 2006]

*WILL NOT WORK WITH CARS BEFORE 2006*
*Compatible OBD2 protocols: ISO9141, ISO14230, CAN*
***PLS READ BELOW and SEND ENQUIRY BEFORE PURCHASE***
IMPORTANT FAQS:

FW V1.28F and after supports display of [MPH/PSI/°F] on radial gauges
Firmware upgrade instructions and an e-copy manual will be sent to you upon item shipped
ACC wire needs to be connected to ensure proper operation of unit [if you face power on and off issue]
RPM redline can be user defined under Warning Setup > RPM
If you encounter “Searching Protocol”, unit is not defective. It is likely due to incompatible OBD2 protocol
If you encounter “TF Card Error”, please reformat the TF card and do a software update
Data display is dependent of available data from ECU (car dependent)
Speed, RPM, voltage, fuel consumption rate can be calibrated if inaccuracy is noticed
Using OBD2 splitter to operate other OBD2 devices concurrently may cause error to Lufi XF

 
Display Data (vehicle dependent)

Pressure data: Intake manifold, turbo, engine fuel, rail, atmospheric (highly vehicle dependent)
Temp. data: Engine oil, water, exhaust, fuel, transmission oil, intake air, charge air, outside
Speed: Average, instantaneous, engine/revolution
Time: Clock, engine run
Fuel consumption: Fuel level, instantaneous, average
Odo, trip dist.
Battery voltage
Air flow sensor, air-fuel ratio
Acc pedal position and value
Gear indicator